DevFeeFinder
FireSet by special district feeCitation Placer County Code ch. 15 art. 15.36; SPFD Res. 15-2017/18; Loomis Res. 18-35 and 20-41

Fire Impact Fee (South Placer Fire Protection District)

Levied by South Placer Fire Protection District on new development in Loomis.

What one house pays

$1,880

For a typical home: a 2,000 sq ft detached house on a 0.13 acre lot, on a new subdivision lot.

Share of Loomis's total
3%
Total one-time fees here
$65,544
Adjustment
Adjusts yearly · ENR construction cost index · July
what the document says

ENR-CCI San Francisco annual

Next expected change
1 Jul 2027

The record

We haven’t read the documents behind this fee yet, so this section is blank rather than guessed.

1,041 of 1,321 fees carry a quoted record; the largest were read first.

Every published rate

Every rate below applies to single-family detached.

RateBasisEffectiveAmount
this home per sq ft — $0.94

“REPORTABLE FEE AMOUNTS / The current Reportable Fees in effect at the end of the fiscal year 2024/25 are shown in the chart below. / Figure 1 - Maximum Fire Impact Fee Schedule / Land Use Category | Maximum Fee / Residential Development | Per Living Sq. Ft. / Single Family Home | $ 0.94 / Multi-Family Housing | $ 1.63 / Mobile Home | $ 1.12 / Assisted Living Facility | $ 1.03 / Notes: The fire impact fee is rounded to the nearest whole cent.”

SPFD Fire Impact Fee Program, Gov. Code 66006(b) annual report, FY 2024-25 · source document ↗

About these figures

Quoted, not summarized. Every amount and fact on this page is copied from the official document it links to. If we couldn’t find something in a document, we leave it blank instead of guessing.

Before any discounts. Some fees offer credits, waivers or phase-ins. They’re listed above but not subtracted, because whether you qualify depends on your project.

Check the date. Fees change. This page shows what was in force on the date at the top, with a link to the document that set it, so you can confirm the current amount yourself. How all of this is put together.

↑↓ navigate↵ openesc close